Replacing motor mount?

[ron350]

I need to replace the bad motor mount on the passenger’s side not sure about the drivers side trans mount.

 

Any tips on what needs to be disconnected before jacking up on the motor?

[Imp558]

Through the wheel well undo the 2 nuts on top and the 2 nuts on bottom. I used a hunk of plywood to spread the weight out on the oilpan. Mine I didn't undo the upper mounts or anything and the tyranny is bolted to the engine by the oil filter housing so it goes where the engine goes.

The top 2 nuts were a bitch.

[Imp558]

Driver's side mount is easier like a 20-30 minute job with a beer in one hand.