crunkGP96 Posted November 17, 2015 Report Share Posted November 17, 2015 Ok so I just installed a new sensor but still no reading on my DIC. Still keeps reading -40 as outside temp. Checked the wiring and it looks to be wired correctly? Previous owner must of changed the plug at some point because it looks like it's a newer one. My vehicle sticker says it had a trip computer so I'm guessing that was the DIC and the sensor already came on it so It wouldn't have to be hard wired by the previous owner? Am I doing something wrong? Do I need to drive it around or something before it reads correctly? This is a brand new sensor. Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
crunkGP96 Posted November 17, 2015 Author Report Share Posted November 17, 2015 Anyone? Couldn't find a thread that tells me if these are the correct wires. Hope it's not a faulty sensor Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
jimmyfloyd Posted November 17, 2015 Report Share Posted November 17, 2015 take a multimeter and read the resistance between the two wires. Also, assuming this was just for testing, but you'll want to shrink wrap the wires to keep water out. crunkGP96 1 Quote Link to comment Share on other sites More sharing options...
crunkGP96 Posted November 17, 2015 Author Report Share Posted November 17, 2015 Appreciate the response. I'll give that a try! Yes wires were bare just for testing! Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.