motor mounts

[bigdman]

ok so i made a new pair of front motor mounts for my 3.1 cutlass. they are made from T-304 stainless steel and with polyuerethane bushings. well the engine does not even move now, and when its running it is loud inside the car. it launches well but i need to change the polyuerethane bushings to rubber, because it vibrates like crazy. :shock: i will post some pics as soon as i can, but does anyone know where i could get some rubber bushings?

[per0781]

the vibration will calm down a little bit in time. any pics?

[GutlessSupreme]

Just use the poly bushings on the engine side and rubber on the other.

[Robby1870]

Just use the poly bushings on the engine side and rubber on the other.

 

Bingo!

 

Thats how I made mine.

[bigdman]

here is one picture of the engine side mount, not bad for being made by a 17 yr old eh? the welds arent so good on this one, i had to refab, that end because i measured wrong :oops:

[19Cutlass94]

I like the poly bushing in the mounts.... makes me feel like I got something a little bit better than a 3100

[bigdman]

i feel like i'm driving a dragster down the strip sounds like it too

[bigdman]

here are the two other pics.

[SigEpCutlass]

not bad at all. nice custom work man. 8)

[bigdman]

thanks, i found some rubber bushings that i can use for the frame side mount. i haven't put them in yet, it was too dark. the pics i took at a gas station, since they have good overhead lighting.